well water 0 water pressure?
September 25th, 2009 | 
Author: i have a gould jet pump and a bladder tank and a well,my pressure dropped to 0- 2 nights ago and the pressure switch which normally clicks on at 30 lbs never did,during the day after i manualy hold up on the switch it hold pressure all day,last night the same thing,do you think its my sucktion line check valve leaking,or my pressure switch?
It is your pressure switch..if it was a leak your pump would be pumping constantly..the points in the pressure switch have welded shut or open… It is a bad switch
would like to increase the cut in of my g.i. H20 presure tank from 20 to 30 but no matter what?
Posted in Gould Pumps
It’s sounds to me like you may have a bad psi switch
I use to work on pumps . you have two contack in the switch and they
have got bad
References :
It is your pressure switch..if it was a leak your pump would be pumping constantly..the points in the pressure switch have welded shut or open… It is a bad switch
References :
I am on well also..and have had to replace my switch
It’s the switch, if it were the suction line, you would get the pump cycling on and off repeatedly.
References :